Keen
modelers must have noticed in the picture on the instruction, that
the front sits too high. So, lowering is a must for this
model. |
The Enzo employs the double
wishbone suspension design, so lowering is easy. |

|
I used a pair of pliers and carefully
bent the base and tip of the A-arm. The wheel hub was raised by about 3
mm. |

|
The push rod has to be either cut short,
or modified as shown. |

|
Now, the front sits fairly low.
You can tell by looking at the gap between the wheel arch and the tire top. |

|
Raising the suspension arms caused an
interference with the wheel housing. I had to cut a portion of
the parts as shown in the right piece in the picture. |

|
|
 |