Page 5 of 6

|
Toyota MR2 (SW20)
Page 5 |
Updated on 04/29/02 |
The
fit of this kit wasn't so good, so test fit has to be throughly
done. After the test fit, I found that the rear of the chassis was
too low, so I cut the tab, and glued a piece of plastic as shown.
This narrowed the gap between the rear tire and the wheel arch as sown in
the picture on Page 1.
|
Fujimi
omitted the radio antenna detail, so I sanded the tip of an Evergreen
plastic rod to represent the corn shape detail. It was painted black
first, then the tip was painted silver. |
Fujimi
sells Toyota, Honda and Mitsubishi emblem set separately. I used
this for the first time for the front and rear badge. I also used the license
plate part for the rear. |
The
tail lights were painted with Gunze's clear orange and clear red.
The darker area was painted from both front and back.
It's almost complete.
|
|
|
Toyota MR2 (SW20)
Page 5 |

|
|