|
|||||||||||||||||||||||||||||||
Ruf CTR Yellow Bird |
|||||||||||||||||||||||||||||||
 Ruf CTR |
|||||||||||||||||||||||||||||||
Published on 06/16/01 |
|||||||||||||||||||||||||||||||
 The front bumper is a cast resin piece. The original part, found in the
kit, was modified by using plastic sheet and epoxy putty. |
|||||||||||||||||||||||||||||||
 The Ruf 17 inch wheels are scratchbuilt also, and the Dunlop D40 tires are
taken from the Fujimi 911 Cabriolet kit. |
|||||||||||||||||||||||||||||||
 The rear bumper is also a cast resin
piece, based on a modified original part. I don't remember how I made the rear wing,
but it was not available in any of the Fujimi kits, so used Tamiya epoxy putty to modify
the Turbo wing. The rear finder was widened by adding another scratchbuilt part, and
epoxy putty was used to smoothed the seam line. (The rear fender of the actual car
is wider than the Carrera by about 20 mm each side.) |
|||||||||||||||||||||||||||||||
 The silencer was basically made from
plastic sheet, and the exhaust headers were made by bending a plastic rod. The turbo
chargers as well as the waste gate assemblies are duplicated from the Fujimi 911 Turbo '85
kit. |
|||||||||||||||||||||||||||||||
Ruf CTR Yellow Bird |
|||||||||||||||||||||||||||||||
Ruf CTR |
|||||||||||||||||||||||||||||||
