VB-CABLE Virtual Audio Device

● (No.1070) VB-CABLE Virtual Audio Device (2020年3月9日)

My main Windows PC was broken and no longer boots,
so the notetype Linux PC was promoted to main PC.

The sound card in my Windows10 PC does not have the stereo mixer.
So, I installed a virtual audio device called "VB-Audio Virtual Cable"
in this PC, and tried to decode 9k6 signal of ELFIN-A using SDR# and

Set as Default Device "CABLE Input" and "CABLE Output" in the tab
"Playback" and "Recording" of Sound settings on Windows10. Then the
received signal can be decoded by the soundmodem software. However,
I cannot hear the reception sound input to PC.
This is my problem to be solved. (See bottom.)

All the related folders on Windows10 should be set to "Full control" as
follows. This [folder] = SDR#, Orbitron, Soundmodem, Agw_Online_Kiss, etc.

Right click on the [folder] -> Properties -> Security -> Users
  -> Edit to change permissions -> Users -> Check "Full control"

SDR# setup on Windows10 upgrade
http://www.ne.jp/asahi/hamradio/je9pel/sdrwin10.htm (EN)
http://www.asahi-net.or.jp/~ei7m-wkt/numbr951.htm   (JP)

SDR# setup + DDE install
http://www.ne.jp/asahi/hamradio/je9pel/sdrshdd2.htm (EN)
http://www.ne.jp/asahi/hamradio/je9pel/sdrshdd3.htm (EN)
http://www.asahi-net.or.jp/~ei7m-wkt/numbr894.htm   (JP)
http://www.asahi-net.or.jp/~ei7m-wkt/numbr927.htm   (JP)

Orbitron + DDE + SDR#(Plugin) automatic tracking
http://www.ne.jp/asahi/hamradio/je9pel/sdrshdde.htm (EN)
http://www.asahi-net.or.jp/~ei7m-wkt/numbr850.htm   (JP)

Settings soundmodem, agw_online_kiss on Windows10
http://dl.dropbox.com/s/bnjrwpqyl6bohgz/9k6decode_je0jdy.pdf (JP)

I was finally able to hear and decode the reception sound from Satellites
in SDR# by installing "VB-Audio Virtual Cable" and "VBRedirect" software
even if PC doesn't have the stereo mixer.


トップ へ戻る.
前のページ へ戻る.
次のページ へ移る.
ホームページ(目次) へ戻る.