Home Car Modeling Mecha Modeling Articles Profile

2..Test Fitting(2)

Up
1..Test Fitting(1)
2..Test Fitting(2)


The skirt assembly is shown.  I was a little disappointed that the side piece is not segmented.  Also the front armor is mold with the center piece, and the base of the pipe not separate either.

I'm gonna separate the front armor, and also separate the side piece into three. 


Figure 2.1
The back pack is simple, and it lacks extra details on the cover unlike other earlier MG kits.  Also, the back pack can be a little taller.  The cover is removable, and the internal mechanism can be seen after finished.

 

 


Figure 2.2
The figure 2.3 shows the internal details of the back pack.  The detail is fair, and it will look good after some washing and dry brushing. 
Figure 2.3

Figure 2.4

The 35mm Gun is well done, but it lacks the sense of integration to the arm despite Katoki's specific instruction.  The arm and hand is supposed to be partially hidden by the gun.

 


Figure 2.5
Figure 2.6

The Gatling Shield is very well done, and it's pleasing to look at.  The shield can't be attached to the arm by itself, because it doesn't have the mount to the arm.  The whole assembly is quite heavy for a relatively small arm.


Figure 2.7

Each barrel is made of two sections, and there are twelve rods total.  It seems that the barrel can be a little smaller in diameter to appeal the fact that they are separate, but it can be easily corrected by using aluminum or brass rods.

Other weapons in the kit are the heat saber and the whip.  The heat saber can be stored behind the shield. 


Figure 2.8

The Gatling Gun is attached to the 35mm Gun.

Ready to kick some Feds butt.

Back Up

Home ] Up ] 1..Test Fitting(1) ] [ 2..Test Fitting(2) ]

Send mail to hirofkd@din.or.jp with questions or comments about this web site.

Copyright © 1999, 2000, 2001 Hiroaki Fukuda

Last modified : 2001-06-16