RX-78 Ver. Ka. Page 3

Back Up

Well, it just fell from the bookshelf.

That's all...(sigh)

The Core Fighter detail can be seen at the bottom of the torso.  
Both of the antennas were broken, so I glued a piece of plastic at each tip.  The picture was taken before the tip was sharpened.  I prefer sharpening the end of the antenna-like object after it's glued, because I have a better grip of the part. 
Most of the parts were not so severely damaged, but unfortunately, the left shoulder pin was broken.  I used a pin-vice to drill a hole, and reinforced the pin with 0.5 mm brass rod.  If the shoulder was thick enough, I would have simply used 3 mm plastic rod.
The bazooka, which was broken into three pieces, was put together again, and it was glued to the rear mount.

The Gundam model was restored, but I don't know when this would happen again as my room is quite messy.

Back Up

 

Home ] Up ] RX-78 Ver. Ka Page 1 ] RX-78 Ver. Ka. Page 2 ] [ RX-78 Ver. Ka. Page 3 ]

Send mail to hirofkd@din.or.jp with questions or comments about this web site.

Copyright © 1999, 2000, 2001 Hiroaki Fukuda

Last modified : 2001-03-11